From: Alexander Peshkov (peshkov@renderx.com)
Date: Tue Jun 22 2004 - 06:12:13 PDT
Hello Chris,
Conditionality for borders is implemented and works fine, but
according to XSL-FO specification you have to specify it for each
component, not for shorthands. Moreover, according to the spec you
must use relative components (which are evaluated with respect to
current writing-mode). Therefore the following properties are valid
and will work:
border-before-width.conditionality="retain"
border-after-width.conditionality="retain"
border-start-width.conditionality="retain"
border-end-width.conditionality="retain"
but these are incorrect:
border-width.conditionality="retain"
border.conditionality="retain"
border-top-width.conditionality="retain"
border-bottom-width.conditionality="retain"
border-left-width.conditionality="retain"
border-right-width.conditionality="retain"
Best regards,
Alexander Peshkov mailto:peshkov@renderx.com
RenderX
CB> Hi,
CB> I'm using XEP 3.7.8 and trying to keep borders consistent on a table which
CB> splits on a page-break. By Consistent, I mean we only specify certain borders
CB> on each cell to avoid overlap (as collapse is not implemented), thus when a
CB> table splits across a page the bottom border of the last cells and top border
CB> of the first cells on new page are not present.
CB> I recently saw a message on this list regarding
CB> border.conditionality="retain", which I though could be used to solve the
CB> problem. However, when running XEP on some FO that uses border.conditionality
CB> I receive the following message:
CB> Attribute border.conditionality cannot occur at element fo:table
CB> I also tried specifying this for the components of the border property, e.g.
CB> border-left-width.conditionality="retain", with the same result.
CB> Is conditionality implemented on borders, and if not, then is there any way to
CB> keep borders consistent when a table is split across a page?
CB> Thanks,
CB> Chris
CB> -------------------
CB> (*) To unsubscribe, send a message with words 'unsubscribe xep-support'
CB> in the body of the message to majordomo@renderx.com from the address
CB> you are subscribed from.
CB> (*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/tos.html
-------------------
(*) To unsubscribe, send a message with words 'unsubscribe xep-support'
in the body of the message to majordomo@renderx.com from the address
you are subscribed from.
(*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/tos.html
This archive was generated by hypermail 2.1.5 : Tue Jun 22 2004 - 06:27:09 PDT