Re: AW: [xep-support] Titlepage in SVG covering whole page

From: Jirka Kosek <>
Date: Mon Oct 09 2006 - 06:19:55 PDT

Ettinger, Christian wrote:

> Thanks for your help, but it did not really solve my problem.
> You are correct, this 'half leading' resulted in a small white line above my SVG. With line-height="1.0" this line vanished and I could make the SVG image 1mm higher.
> But, there is still a tine white line below the SVG, it is still not possible to make it as high as the page.
> I just want the SVG to be rendered even if it has the same size (or is bigger) than the page! Is this possible with XEP?

You can put your image into block-container and then use absolute
positioning to fine tune placement of image, e.g.:

<fo:block-container absolute-position="absolute"
                              top="-1cm" >

   Jirka Kosek     e-mail:
   Profesionální školení a poradenství v oblasti technologií XML.
      Podívejte se na náš nově spuštěný web
        Podrobný přehled školení
                    Nejbližší termíny školení:
     ** XSLT 23.-26.10.2006 ** XML schémata 13.-15.11.2006 **
      ** DocBook 11.-13.12.2006 ** XSL-FO 11.-12.12.2006 **
------------------------------------------------------------------    Blog mostly about XML for English readers

(*) To unsubscribe, send a message with words 'unsubscribe xep-support'
in the body of the message to from the address
you are subscribed from.
(*) By using the Service, you expressly agree to these Terms of Service

Received on Mon Oct 9 06:31:36 2006

This archive was generated by hypermail 2.1.8 : Mon Oct 09 2006 - 06:31:37 PDT