Re[2]: [xep-support] Table positioning

From: Alexander Peshkov (
Date: Mon Dec 15 2003 - 00:53:25 PST

  • Next message: Alexander Peshkov: "Re[2]: [xep-support] Table positioning"

    Hello Brian ,

    AP> However it's not possible to place this table at arbitrary point of the flow
    AP> and make float to the top of the page - there is no such means in XSL FO.

    Sorry, it's not the case - I forget about before float. According to
    XSL FO spec before floats are page-wide irrespective of the number of
    columns on the page. It could be of some use for you.

    Best regards,
    Alexander Peshkov

    CBD>> Hello,

    CBD>> I'm trying to position a page-width table to the top of a two column page
    CBD>> (in a pdf). I'm pretty sure it can be done, but I just started learning
    CBD>> XSL-FO a few weeks ago, and haven't been able to figure out how to do it
    CBD>> yet. Are there any tutorials or resources that could help?

    CBD>> Thanks.

    (*) To unsubscribe, send a message with words 'unsubscribe xep-support'
    in the body of the message to from the address
    you are subscribed from.
    (*) By using the Service, you expressly agree to these Terms of Service

    This archive was generated by hypermail 2.1.5 : Mon Dec 15 2003 - 01:05:01 PST