[xep-support] rx:flow-section and indents

Hi,

I have a column layout issue. I've been using an rx:flow-section to change
mid-page between a 1 and many column layout. This works well and even lines
between columns seem to be working.
Now I have some situations where I need to effectively change the margins of
the column layout with respect to the rest of the page.
I was hoping to set start-indent and end-indent on the rx:flow-section but
that doesn't seem to have any effect at all.
Setting up a wrapper block with the indents e.g.

<rx:flow-section>
    <fo:block start-indent="0.5in" end-indent="0.5in">
         <xsl:apply-templates/>
...

doesn't work for more than one column because both the left and right indent
are applied to all columns.
Does anyone have a workaround or solution to this problem? Note that I can't
change the margins of the previous flows.

Regards,

Justin Lipton

Exari Systems
Boston | London | Melbourne | Munich
Test drive our software online - www.exari.com/demo-trial.html
Read our blog on document assembly - blog.exari.com

-------------------
(*) To unsubscribe, send a message with words 'unsubscribe xep-support'
in the body of the message to majordomo@renderx.com from the address
you are subscribed from.
(*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/terms-of-service.html
Received on Thu Mar 18 20:56:35 2010