Re: [xep-support] Printer's Pagination

From: Alexander Peshkov <peshkov@renderx.com>
Date: Wed May 18 2005 - 03:13:11 PDT

Hello Peter,

Actually XEP DevKit includes a sample called 'PostProcessing' that
does exactly what you want - it repositions formatted pages turning an
ordinary document with sequential pages into a saddle-stitched booklet.

Best regards,
Alexander Peshkov mailto:peshkov@renderx.com
RenderX

PS> Does anyone know whether XEP (or XSL) supports printer's pagination? I want
PS> to create an 8.5" by 11" single-fold brochure where page 1 is the front
PS> cover, pages 2 and 3 are the interior spread and page 4 is the back cover. I
PS> want to output this to a print-ready PDF file that would actually consist of
PS> two sheets (spreads) 17" wide by 11" high. The first sheet would be page 4
PS> on the left, page 1 on the right, the second would be page 2 on the left,
PS> page 3 on the right. Can this be done without a lot of complex XSL
PS> programming?

PS> Thanks,
PS> Peter

PS> -------------------
PS> (*) To unsubscribe, send a message with words 'unsubscribe xep-support'
PS> in the body of the message to majordomo@renderx.com from the address
PS> you are subscribed from.
PS> (*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/tos.html

-------------------
(*) To unsubscribe, send a message with words 'unsubscribe xep-support'
in the body of the message to majordomo@renderx.com from the address
you are subscribed from.
(*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/tos.html
Received on Wed May 18 04:11:01 2005

This archive was generated by hypermail 2.1.8 : Wed May 18 2005 - 04:11:04 PDT